Unincorporated Elmore County building inspections
VerifiedInspection sequence, scheduling, and re-inspection fees for building permits in Unincorporated Elmore County, Idaho.
Verified 2026-07-08 · Source
How to schedule
Inspections are requested through the building department below.
- Address
- 2280 American Legion Blvd, Mountain Home, ID 83647
- Phone
- 208-587-2142
- Office hours
- Mon–Fri 8:00 AM – 5:00 PM
- Website
- Official site
Published scheduling rules
- Elmore County spans a huge elevation range (Mountain Home valley floor up through Featherville, Pine, Atlanta, and Rocky Bar in the mountains) — footing depth, snow load, and inspection scheduling all vary by elevation zone. Structures above ~5,000 ft (above Tollgate) require an engineer-stamped 120 lbs/sq ft snow load / 115 mph wind report. (General)
Inspection sequence
Applies to: Commercial Building Permit (New Construction / Tenant Improvement)
- 1
Footing/Foundation
Verify footing depth and foundation layout before backfill
- 2
Framing/Structural
After structural framing complete and before wall cover
- 3
Final
All work complete per approved, stamped plans
Applies to: Residential Building Permit (New Construction / Addition)
- 1
Footing/Foundation
Verify footing depth per local zone (24"/30"/36" below frost line depending on elevation) and foundation layout before backfill
- 2
Framing
After framing, sheathing, and rough-in trades complete, before insulation or wall cover
- 3
Final
All work complete per approved plans; property address marker must be installed by the county before final inspection
Applies to: Agricultural Building Exemption (Notice of Proposed New Agricultural Building)
- 1
Site/Setback Inspection
Confirms conformity with road setbacks, County Ordinance setbacks, and utility setbacks; the structure itself is NOT inspected for IBC/IRC compliance since it is exempt
- 2
Random Compliance Inspection (within 12 months)
May occur within 12 months after final approval to confirm the structure's use remains agricultural in nature; if a non-agricultural use is found, the owner must obtain all required permits and pass all applicable inspections
Applies to: EV Charger / EVSE Permit
- 1
Electrical Rough/Final (Idaho DOPL, state permit)
Conductor sizing, breaker/panel work, grounding, and EVSE equipment connection verified under the separate state electrical permit — not performed by Elmore County
- 2
Structural Final (County, only if applicable)
Required only if the EV charger installation is paired with new county-permitted construction (carport, garage, accessory structure)
Applies to: Manufactured Home Placement Permit
- 1
Foundation/Set
Verify permanent foundation and blocking/anchoring per 2018 Idaho Manufactured Home Installation Standards
- 2
Final
Utility connections, skirting, and address marker verified; electrical/plumbing tie-ins inspected separately by Idaho DOPL
Final inspection only: Solar Roof/Ground Installation Permit
Re-inspection fees
Sources & verification
Verified against official sources. Last reviewed 2026-07-08.
Fees, timelines, and adopted codes are researched from each jurisdiction's published records — see how we verify. Requirements change and vary by project, so always confirm the current details with the Unincorporated Elmore County building department before you submit. PermitBase is an independent reference and is not affiliated with any government agency.
Unincorporated Elmore County building permits
Get alerts for Unincorporated Elmore County
We'll email you when Unincorporated Elmore County's fees, documents, or codes change — not often.
We only use your email to send permit updates. No spam, unsubscribe anytime. Privacy.