Gila Bend building inspections
VerifiedInspection sequence, scheduling, and re-inspection fees for building permits in Gila Bend, Arizona.
Verified 2026-07-06 · Source
How to schedule
Inspections are requested through the building department below.
- Address
- 644 W. Pima St., P.O. Box A, Gila Bend, AZ 85337
- Phone
- 928-235-6362 (Community Development); 480-489-2463 (Willdan Engineering, building safety/inspections)
- Office hours
- Monday - Friday, 8:00 a.m. - 4:00 p.m. Building plan review, permit issuance, and inspections are administered under contract by Willdan Engineering; the Town's Community and Economic Development office handles zoning/planning intake at the same address.
- Website
- Official site
Inspection sequence
Applies to: Residential Building Permit (New Single-Family Residence)
- 1
Exterior/Interior Footings
Setbacks per approved site plan; depth, width, reinforcement steel placement; Ufer ground in place at electric meter location
- 2
Stem Wall
Forms, reinforcing steel size/location, hold-down straps per approved plans, before pour
- 3
Framing, Rough Plumbing, Mechanical & Electrical
Combined inspection for single-family construction; no insulation or wallboard installed until approved
- 4
Drywall / Exterior Lath
Fasteners, material, penetrations; foam board/lath wire/vapor barrier/weep screed installation per manufacturer ICBO/ICC/NES reports
- 5
Final Inspection
Compliance with Building, Electrical, Plumbing, and Mechanical Code requirements and approved plans
Applies to: Plumbing Permit
- 1
Under-Slab Drain & Material / Water Lines
Size, slope/fall, fittings, cleanouts; water test on drains and pressure test on water lines; bedded in sand or approved material
- 2
Rough Plumbing (combined with Framing/Mechanical/Electrical)
After pipes installed, before walls closed
- 3
Water Service
Piping from meter to structure verified for size, depth, material, bedding, pressure test; backflow preventer size/type/location verified, with certified testing prior to Certificate of Occupancy if required
- 4
Final
Fixtures connected, water heater and gas connections verified, no leaks
Applies to: Electrical Permit
- 1
Electric, Underground
Underground conduit or approved direct-burial cable checked for depth, size, and type
- 2
Rough Electrical (combined with Framing/Plumbing/Mechanical)
Wiring, box placement, panel connections before walls closed
- 3
Final
Devices installed, panel labeled, protections verified per 2005 NEC as adopted
Applies to: Fire Sprinkler & Fire Alarm Permit
- 1
Fire (Underground)
Underground fire-service piping supplying the sprinkler system inspected for depth, size, and type before backfill; tracked as its own review/inspection category (6 working days initial plan review per the Town's Turn Around Times document)
- 2
Rough Sprinkler/Alarm
Piping, sprinkler heads, alarm devices, and wiring verified before ceiling/wall close-in
- 3
Final Fire Sprinkler/Alarm
Hydrostatic/flow test and alarm functional test performed and verified against NFPA standards, the 2006 IFC as adopted, and approved plans
Applies to: Residential Addition / Remodel Permit
- 1
Footing
Required before concrete pour for additions
- 2
Framing, Rough Plumbing, Mechanical & Electrical
Combined inspection before insulation/wallboard installed
- 3
Final
Completed work verified against approved plans
Applies to: EV Charger / EVSE Permit
- 1
Rough Electrical
EVSE circuit wiring, box placement, and panel connections before walls closed, per the Town's standard combined trade rough inspection
- 2
Final
EVSE unit connections, breaker/disconnect, and grounding verified per 2005 NEC as adopted
Applies to: Manufactured Home / Factory-Built Building Permit
- 1
Placement/Foundation
Verifies tie-down, foundation, and zoning-compliant siting for the manufactured or factory-built unit
- 2
Final
Utility connections and site improvements verified complete
Applies to: Mechanical / HVAC Permit
- 1
Rough Mechanical (combined with Framing/Plumbing/Electrical)
Ductwork and equipment placement before walls closed
- 2
Final
Equipment operational, clearances and combustion air verified
Applies to: Residential Solar Photovoltaic (PV) Permit
- 1
Rough Electrical
Interconnection wiring, disconnects, and conduit runs verified per the 2005 NEC before energizing, combined with Framing/Plumbing/Mechanical inspection where applicable
- 2
Final
Panel mounting, racking attachment, roof penetration sealing (if a building permit was required), and electrical connections verified against approved plans
Applies to: Sign Permit (Commercial/Business Signage)
- 1
Initial Sign Inspection
Installed sign verified against the approved application (type, overall height, width, lighting, clearance from ground) and Zoning Ordinance Article VIII district standards; included in the One Sign fee
- 2
Additional Sign Inspection
Applies to projects with multiple signs beyond the first, or where reinspection is required; billed at the Additional Sign Inspections rate if not already bundled
Applies to: Swimming Pool / Spa Permit
- 1
Pre-Pour / Under-Slab
Soil compaction, protection of waste/water lines, reinforcement placement, slab thickness check before pour
- 2
Final
Pool barrier compliance (5-ft height, self-closing/self-latching gates, 4-inch-sphere test) verified along with structural completion
Final inspection only: Certificate of Occupancy / Change of Use, Demolition Permit, Fence Permit
Re-inspection fees
Sources & verification
Verified against official sources. Last reviewed 2026-07-06.
Fees, timelines, and adopted codes are researched from each jurisdiction's published records — see how we verify. Requirements change and vary by project, so always confirm the current details with the Gila Bend building department before you submit. PermitBase is an independent reference and is not affiliated with any government agency.
Gila Bend building permits
Get alerts for Gila Bend
We'll email you when Gila Bend's fees, documents, or codes change — not often.
We only use your email to send permit updates. No spam, unsubscribe anytime. Privacy.