Skip to main content
PermitBase

Springerville building inspections

Verified

Inspection sequence, scheduling, and re-inspection fees for building permits in Springerville, Arizona.

Verified 2026-07-07 · Source

How to schedule

Inspections are requested through the building department below.

Address
418 E. Main St., Springerville, AZ 85938
Phone
928-333-2656 ext. 227 (Building Department); 928-333-2656 (Planning & Zoning main line); fax 928-333-5598
Office hours
Not published on the Town's Building Department page as of this review (no explicit hours-of-operation statement was found on the Building Department, Community Development, or Contact Us pages). Applicants must contact the Building Department a minimum of twenty-four (24) hours in advance to schedule an inspection, per the Town's own permit application forms.

Inspection sequence

Applies to: Residential Building Permit (New Construction, Additions, Remodels)

  1. 1

    Foundation/Footing

    Before concrete pour

  2. 2

    Rough-In (Framing, Electrical, Plumbing, Mechanical)

    Structural framing and rough trade work before closing walls

  3. 3

    Final / Certificate of Occupancy

    All work complete per approved plans; Certificate of Occupancy issued (sent upon request)

Applies to: Demolition Permit

  1. 1

    Pre-Demolition

    Verifies all utilities and water/sewer facilities are disconnected

  2. 2

    Final

    Required after all demolition and final clean-up has been completed

Applies to: Electric Vehicle (EV) Charging Station Permit

  1. 1

    Rough-In

    Wiring/circuit and any panel work before enclosure

  2. 2

    Final

    Charging equipment installed and operational, connections verified

Applies to: Manufactured Home / Factory-Built Building (FBB) Installation Permit

  1. 1

    Installation Inspection (minimum 2 required)

    Verifies permit is present/visible, penetrometer/soil compaction, utility testing verification (gas required on all new and used units), full serial number, HUD labels/FBB manufacturer's certificate, installation certificate/blocks, piers/pads/anchoring, marriage-line connections, close-off/weatherproofing, gas pressure tests, electrical connections, water/sewer connections, HVAC pad/breaker sizing, per the State Office of Manufactured Housing inspection checklist

  2. 2

    Accessory Structure Inspection

    One of the minimum 2 required inspections is specifically reserved for accessory structures (awning, garage, porch, skirting/retaining), if applicable

Applies to: Photovoltaic (Solar) Permit

  1. 1

    Rough Electrical

    Conduit runs, wire sizing, disconnect placement before energizing

  2. 2

    Final

    Panel mounting, racking attachment, roof penetration sealing, electrical connections, and interconnection point verified

Applies to: Storage/Shed Building Permit

  1. 1

    Foundation

    Before concrete pour, verifying footing layout

  2. 2

    Final

    Complete structure verified against approved plans; a full list of required inspections is provided upon request

Applies to: Utility/Mechanical Permit (Electrical, Plumbing, Mechanical)

  1. 1

    Rough-In

    Wiring, piping, or equipment placement before enclosure

  2. 2

    Final

    Devices/fixtures/equipment installed and operational, connections verified

Final inspection only: Sign Permit, Wall/Fence Permit

Sources & verification

Verified against official sources. Last reviewed 2026-07-07.

Fees, timelines, and adopted codes are researched from each jurisdiction's published records — see how we verify. Requirements change and vary by project, so always confirm the current details with the Springerville building department before you submit. PermitBase is an independent reference and is not affiliated with any government agency.

Springerville building permits

Get alerts for Springerville

We'll email you when Springerville's fees, documents, or codes change — not often.

We only use your email to send permit updates. No spam, unsubscribe anytime. Privacy.