Eagle building inspections
VerifiedInspection sequence, scheduling, and re-inspection fees for building permits in Eagle, Colorado.
Verified 2026-07-06 · Source
How to schedule
Inspections are requested through the building department below.
- Address
- 200 Broadway, PO Box 609, Eagle, CO 81631
- Phone
- 970-328-9565
- Office hours
- General Building Division line (970) 328-9565; Inspection Hotline (970) 328-9626 (must call by 4:00 PM for next available inspection date). Due to limited staff capacity, the Town's own Building Department page states initial response times for phone calls and emails are approximately 3-5 business days. In-person appointments are recommended and should be scheduled by phone or email rather than walk-in. Chief Building Official: Dan Brown.
- Website
- Official site
Published scheduling rules
- All plan submittals and inspection requests for registered contractors go through the Community Core online portal; paper plans are not accepted. (Residential Building Permit (New Construction))
- Inspections are scheduled directly with the State's assigned inspector, not the Town's Inspection Hotline (Electrical Permit)
Inspection sequence
Applies to: Residential Addition / Interior Remodel Permit
- 1
Foundation (additions with new footings only)
Before concrete pour, per 48-inch minimum frost depth
- 2
Rough Frame
Framing complete, connection to existing structure verified
- 3
Rough Plumbing / Mechanical
Trade rough-ins before concealment
- 4
Final Inspection
All work complete per approved plans
Applies to: Residential Building Permit (New Construction)
- 1
Foundation
Before concrete pour, per 48-inch minimum frost depth
- 2
Framing
Structural framing complete before cover
- 3
Rough Plumbing / Mechanical
Trade rough-ins before concealment (rough electrical is scheduled separately with the Colorado DPO, not the Town)
- 4
Final Inspection
All work complete per approved plans and applicable codes; Certificate of Occupancy issued on passing
Applies to: Electrical Permit
- 1
Rough Electrical
Scheduled directly with the State-assigned electrical inspector, not the Town
- 2
Final Inspection
State inspector verifies devices, panel labeling, and energization
Applies to: EV Charger / EVSE Permit (State of Colorado Electrical Board)
- 1
Rough-In
Wiring and conduit installed before walls closed (if applicable); scheduled directly with the State-assigned electrical inspector, not the Town
- 2
Final
Charger circuit/unit installed, breaker sized correctly, energized; State inspector verifies devices and energization
Applies to: Mechanical / HVAC Permit
- 1
Rough Mechanical
Ductwork, flues, and equipment placement before concealment
- 2
Final Inspection
Equipment operational, combustion air and venting verified
Applies to: Plumbing Permit
- 1
Rough Plumbing
Pipe, drain, waste, and vent installation before concealment
- 2
Final Inspection
Fixtures connected, no leaks, proper venting verified
Applies to: Solar PV Permit (Split Town/State Jurisdiction)
- 1
Town Building Inspection (Structural/Racking)
Town of Eagle Building Department inspects the structural/racking portion of the installation
- 2
State Electrical Inspection
Colorado State Electrical Board (DORA) inspects the interconnection/electrical work, since this is not handled by the Town
Final inspection only: Demolition Permit (Move or Demolish), Fence and Retaining Wall Permit, Roofing Permit (Re-Roof, Single-Family)
Sources & verification
Verified against official sources. Last reviewed 2026-07-06.
Fees, timelines, and adopted codes are researched from each jurisdiction's published records — see how we verify. Requirements change and vary by project, so always confirm the current details with the Eagle building department before you submit. PermitBase is an independent reference and is not affiliated with any government agency.
Eagle building permits
Get alerts for Eagle
We'll email you when Eagle's fees, documents, or codes change — not often.
We only use your email to send permit updates. No spam, unsubscribe anytime. Privacy.