Skip to main content
PermitBase

Electrical Permit in Jerome, Arizona

Required for electrical installation, alteration, or repair work in Jerome, governed by the 2011 National Electrical Code (NEC) as adopted by the Town (Resolution 548) — notably two editions behind the NEC cycle used by most other Arizona jurisdictions in this dataset.

Verified 2026-07-07 · Source

When you need this permit

  • Electrical permit required for new electrical service, panel work, and other hard-wired electrical work
  • Governed by the 2011 NEC as adopted by the Town of Jerome (Resolution 548)
  • New Electrical Service is a specifically itemized flat-fee permit type on the Town's Fee Schedule
  • Combination permits covering electrical, plumbing, or mechanical trades together are available for valuations up to $3,000 at a flat per-trade rate; above $3,000, the general Valuation and Fee Schedule applies instead
  • Exterior electrical work (fixtures, wiring visible from the street) may separately trigger Design Review if it is part of a broader exterior modification, though routine like-for-like electrical repair is not itself a Design Review trigger

Required documents

Check off what you have — your progress is saved on this device.

Not ready yet0 of 2 required documents checked.

This checker covers one permit. A full project usually triggers several — our paid checklist will assemble all of them, from $29

Fee schedule

New Electrical ServiceTown of Jerome Official Fee Schedule, Schedule A-1, Specific Fees
$50.00
Combination Permit (electrical, plumbing, or mechanical), valuation up to $3,000Town of Jerome Official Fee Schedule, Schedule A-1
$50.00 for each trade
Combination Permit (electrical, plumbing, or mechanical), valuation over $3,000Town of Jerome Official Fee Schedule, Schedule A-1
Use Valuation and Fee Schedule

Review timeline

Plan review
Not published — contact the department

How long did your Electrical Permit permit actually take in Jerome?

Anonymous — one question, no email. Answers are combined and only shown once at least 5 people have reported.

Inspection process

  1. 1

    Rough-In

    Wiring and panel connections before walls are closed

  2. 2

    Final

    Devices installed and panel labeled per 2011 NEC

See the full Jerome inspection guide — scheduling & re-inspection fees →

Tips

  • Jerome's adopted electrical code (2011 NEC, Resolution 548) is notably older than the 2023 NEC used by most nearby Yavapai County jurisdictions in this dataset (e.g., Clarkdale, Cottonwood) — confirm with the Building Inspector whether any newer NEC provisions are being applied in practice despite the formally adopted 2011 edition.
  • A flat $50 combination-permit rate applies per trade (electrical/plumbing/mechanical together) for projects valued up to $3,000 — useful for small remodels bundling multiple trades under one valuation threshold.

Frequently asked questions

Jerome requires an electrical permit for: Electrical permit required for new electrical service, panel work, and other hard-wired electrical work; Governed by the 2011 NEC as adopted by the Town of Jerome (Resolution 548); New Electrical Service is a specifically itemized flat-fee permit type on the Town's Fee Schedule; Combination permits covering electrical, plumbing, or mechanical trades together are available for valuations up to $3,000 at a flat per-trade rate; above $3,000, the general Valuation and Fee Schedule applies instead; Exterior electrical work (fixtures, wiring visible from the street) may separately trigger Design Review if it is part of a broader exterior modification, though routine like-for-like electrical repair is not itself a Design Review trigger. If your project isn't listed, confirm with Town of Jerome Building Department (Planning & Zoning Dept.) — Building Inspector at 928-634-7943 before starting work.

$50.00 flat fee for New Electrical Service, per the Town of Jerome Official Fee Schedule (Schedule A-1, current as of July 1, 2026). Combination permits bundling electrical with plumbing or mechanical trades on a project valued up to $3,000 are also $50.00 per trade.

Jerome does not publish a plan-review timeline for this permit. Contact Town of Jerome Building Department (Planning & Zoning Dept.) — Building Inspector at 928-634-7943 for current turnaround.

You'll need: Building/Electrical Permit Application; Electrical Plan / Load Calculation. See the required-documents checklist on this page for details on each.

Jerome requires 2 inspection(s) for an electrical permit, in order: Rough-In, Final. Schedule each through Town of Jerome Building Department (Planning & Zoning Dept.) — Building Inspector (928-634-7943).

Apply through Town of Jerome Building Department (Planning & Zoning Dept.) — Building Inspector at 600 Clark Street, P.O. Box 335, Jerome, AZ 86331. Phone: 928-634-7943, email: b.wolstencroft@jerome.az.gov. Office hours: Town Hall: Monday - Thursday, 8:00 a.m. to 5:00 p.m. Building Inspector: Barry Wolstencroft (b.wolstencroft@jerome.az.gov, 928-634-7943, fax 928-634-0715). Building permit applications are filed at Town Hall (PO Box 335 / 600 Clark St.) only AFTER the project has received required approval from the Design Review Board and/or Zoning Administrator; inspections are scheduled approximately one week in advance and the Town states it is not liable for work delays due to inspection scheduling.. Official information: https://jerome.az.gov/building-inspection.

Jerome, Arizona has adopted: Arizona has NO statewide mandatory building code floor for general construction — code adoption is a per-city/county authority under state enabling statutes (e.g., A.R.S. Title 9 for municipalities). Despite its very small size (population approximately 450), the Town of Jerome runs its own genuinely independent Building Department with a named Building Inspector (Barry Wolstencroft), its own adopted code chapter (Town Code Chapter 7, Building and Safety Codes), and its own Council-adopted fee schedule (Schedule A-1) — it does NOT defer building-permit administration to Yavapai County. Source: Town of Jerome Building Inspection page (jerome.az.gov/building-inspection) and Building Codes page (jerome.az.gov/building-codes).; 2012 International Building Code (IBC), adopted by Resolution 544. Source: Town of Jerome Building Codes page (jerome.az.gov/building-codes).; 2012 International Residential Code for One- and Two-Family Dwellings (IRC), adopted by Resolution 545. Source: Town of Jerome Building Codes page.; 2012 International Plumbing Code (IPC), including Appendices B, C, D, and E, adopted by Resolution 547. Source: Town of Jerome Building Codes page.; 2011 National Electrical Code (NEC), adopted by Resolution 548 — notably TWO editions behind the electrical-code cycle used by most other AZ jurisdictions reviewed in this dataset (which have generally moved to the 2023 NEC); confirmed as currently listed on the Town's own Building Codes page, not assumed. Source: Town of Jerome Building Codes page.; 2012 International Mechanical Code (IMC), adopted by Resolution 546. Source: Town of Jerome Building Codes page.; 2012 International Fuel Gas Code (IFGC), including Appendices A, B, C, and D, adopted by Resolution 549. Source: Town of Jerome Building Codes page.; 2012 International Property Maintenance Code (IPMC), adopted by Resolution 550 and Ordinance 430. Source: Town of Jerome Building Codes page.; Appendix 33 of the 1997 Uniform Building Code (UBC), serving as the Town's Grading Ordinance, adopted by Ordinance 358. Source: Town of Jerome Building Codes page.; Town of Jerome Administrative Code (2003 Edition), adopted by Ordinance 358 — governs local permit administration provisions layered on top of the ICC codes (e.g., the Section 108.8 reinspection-fee citation used in the Town's own Fee Schedule). Source: Town of Jerome Building Codes page.; 2018 International Fire Code (IFC), adopted by Resolution 635 — notably a much newer edition than the 2012-vintage building/residential/plumbing/mechanical/fuel-gas code set, and the only code in Jerome's adopted set current within the last decade. Source: Town of Jerome Building Codes page.; IMPORTANT — Historic Overlay District (Jerome Zoning Ordinance Section 511.C): the Historic Overlay District boundary 'shall include all areas within the corporate limits of the Town of Jerome' — i.e., the ENTIRE town is inside the Historic Overlay District, not just a subset of downtown parcels. As a result, Design Review Board (or, for minor listed items, Zoning Administrator) approval under Zoning Ordinance Section 304 is a mandatory prerequisite BEFORE a building permit application can even be submitted to the Building Inspector, for nearly every exterior construction project Town-wide. Source: Jerome Zoning Ordinance (current through July 2024), Sections 304 and 511 (jerome.az.gov/documents/76/Zoning_Ordinance_updated_thru_July_2024.pdf); Building Permit Application Packet ('We provide the following information to assist you in applying for a permit once the Design Review Board has approved your project.').. Local amendments apply — see the Jerome overview page for the full list.

Sources & verification

Verified against official sources. Last reviewed 2026-07-07.

Fees, timelines, and adopted codes are researched from each jurisdiction's published records — see how we verify. Requirements change and vary by project, so always confirm the current details with the Jerome building department before you submit. PermitBase is an independent reference and is not affiliated with any government agency.