Fire Alarm System Permit / Plan Review — Alpine, Utah · Requirements sheet
Reviewed 2026-07-21 · Source: https://www.alpineut.gov/169/Public-Safety
PermitBase is an independent reference and is not affiliated with any government agency. Requirements change and vary by project — confirm current details with the building department before you submit.
Fire Alarm System Permit / Plan Review in Alpine, Utah
Alpine City's Building Department does not review or permit fire alarm systems itself, and Alpine's Consolidated Fee Schedule (effective 11/11/2025, full text reviewed 2026-07-21) contains no 'fire alarm' fee line item at all. Per Alpine's official Public Safety page, fire code enforcement for Alpine is provided by Lone Peak Fire District (serving Alpine, Highland, and Cedar Hills), the local fire authority responsible for enforcing the state fire code in Alpine under Utah Code § 53-7-104(2). A direct check of Lone Peak Fire District's own website (lonepeakfire.com) found no published fire alarm permit application, fee schedule, or plan-review guidance of any kind. The Utah State Fire Marshal's Office separately publishes a statewide Fire Alarm Plan Review Submittal Form with its own published fee ($75 minimum, or $0.022 per square foot of review scope, whichever is greater) — cited here as the best available grounded fee reference in the absence of any Lone Peak-published figure — but the State Fire Marshal's own enforcement jurisdiction under Utah Code § 53-7-104(3) is limited to areas outside corporate cities/fire districts, state/school property, and certain institutional occupancies (or by request of the local fire official), so it is not certain this state-level fee is what Lone Peak Fire District actually charges for an ordinary commercial fire alarm system in Alpine. Applicants should confirm directly with Lone Peak Fire District (801-763-5365) which review path and fee apply to a specific project.
Reviewed 2026-07-21 · Source
When you need this permit
- Installation of a fire alarm system in a building located in Alpine City, where required by the adopted fire/building code for the occupancy or use
- Fire alarm system plans must be reviewed and approved by the applicable fire code authority before installation, separate from Alpine's own Building Permit process
- Submittal must include a floor plan showing room size/use, occupancy type, project code analysis, alarm-initiating/notification device locations, alarm control/trouble signaling equipment, annunciation, power connection, battery calculations, conductor type/sizes, voltage drop calculations, manufacturer cut sheets, and ceiling height/construction details, per the Utah State Fire Marshal's Fire Alarm Plan Review Submittal Form
Required documents
Check off what you have — your progress is saved on this device.
Not ready yet — 0 of 2 required documents checked.
This checker covers one permit. A full project usually triggers several — our checklist will assemble all of them, free →
Fee schedule
Utah State Fire Marshal's Office, Fire Alarm Plan Review Submittal Form: 'SQUARE FT x .022$ = $______. Show full citationHide
Utah State Fire Marshal's Office, Fire Alarm Plan Review Submittal Form: 'SQUARE FT x .022$ = $______. Note: Minimum fee is $75.' Cited as the best available grounded fee reference — Alpine's own Consolidated Fee Schedule has no fire alarm line item, and Lone Peak Fire District (Alpine's local fire authority per Utah Code § 53-7-104(2)) publishes no fee schedule of its own; whether this state-level fee is what actually applies to an Alpine project has not been independently confirmed with Lone Peak Fire District.Review timeline
Inspection process
- 1
Fire Alarm Inspection and Testing
Inspection and acceptance testing of the installed system per NFPA 72 (2022 Edition), adopted by Utah Administrative Rule R710-11, 'Standards for inspecting and testing fire alarm systems.'
See the full Alpine inspection guide — scheduling & re-inspection fees →
Tips
- Lone Peak Fire District, not Alpine City's own Building Department, is the fire authority for Alpine per Alpine's official Public Safety page — confirm fire alarm plan review and fees directly with Lone Peak Fire District (5582 Parkway West Drive, Highland, UT 84003; 801-763-5365) before assuming a specific fee applies.
- The Utah State Fire Marshal's submittal checklist requires extensive documentation (voltage drop calculations, battery calculations, device locations, cut sheets, etc.) — assemble this package before submitting, regardless of which fire authority ultimately reviews the plans.
- This fire alarm review is separate from, and in addition to, Alpine's own Commercial Building Permit or Commercial Tenant Improvement Permit process for the same project.
Frequently asked questions
Sources & verification
Key facts verified against official sources. Last reviewed 2026-07-21.
Fee schedules
Codes & ordinances
Department & other records
Fees, timelines, and adopted codes are researched from each jurisdiction's published records — see how we verify. Requirements change and vary by project, so always confirm the current details with the Alpine building department before you submit. PermitBase is an independent reference and is not affiliated with any government agency.
Alpine's permit history isn't searchable here yet
This page covers what the permit requires. What we don't have for Alpine yet is the record of permits actually issued — the history you'd search by street address. That is a gap in our coverage, not a statement about any particular property.
Your email, and the place — never an address. We only use it to tell you when Alpine lands. Privacy.
Other permits in Alpine
Fire Alarm System Permit / Plan Review in other cities
Compare fire alarm system permit / plan review fees across Utah →
Look up this fee in a different city →
Now live
Build your Alpine project checklist
Describe your project once and get every permit, document, and fee it triggers in Alpine — in one checklist. Free, for any city and any number of projects.
Get started →