Commercial Tenant Finish / Remodel Permit in Ault, Colorado

Ault requires a commercial tenant finish / remodel permit for: Building permit application giving project description, square footage, total project valuation and electrical valuation, use of surrounding spaces, type of construction, and occupancy group; One electronic set of: architectural plans (stamped by a Colorado-licensed architect or engineer, including floor plan, wall section details, building section, fire-rating details, code summary); structural plans (stamped, if structural changes such as bearing wall removal are involved); electrical plans (stamped; load calculations, one-line diagrams, and fault current analysis required for added circuits/service upgrades/emergency lighting); mechanical/plumbing plans (stamped, if HVAC or plumbing systems are changed); For restaurants/commercial kitchens specifically: grease interceptor sizing per adopted Plumbing Code where applicable; fire sprinkler system if serving liquor and over 5,000 sq ft; Type I/Type II hood requirements per equipment; two exits (not through kitchen/storage) for occupant load 50+; Health Department (Weld or Larimer County) approval required before final inspection/Certificate of Occupancy; seating plan for dining areas; All plan sheets must bear the original seal of a Colorado-licensed architect or engineer unless exempted under section 12-4-112 C.R.S.. If your project isn't listed, confirm with Town of Ault (building official, plan review, and inspection services contracted to SAFEbuilt Colorado) at 970-834-2844 before starting work.

In Ault, the published Building Permit Fee (1997 UBC Table 1-A valuation-based schedule) is: $23.00 minimum, scaling per Exhibit B valuation tiers. Additional published fees: Plan Review Fee — Small Remodel and Commercial Projects — 30% of Building Permit Fee; Plan Review Fee — Multi-Family and Commercial Projects (larger scope) — 65% of Building Permit Fee. These are the jurisdiction's own published figures — see the fee schedule table and source citations on this page.

Ault does not publish a plan-review timeline for this permit. Contact Town of Ault (building official, plan review, and inspection services contracted to SAFEbuilt Colorado) at 970-834-2844 for current turnaround.

You'll need: Building Permit Application (commercial tenant finish/remodel scope); Commercial Tenant Finish/Remodel Plan Submittal Procedure (SAFEbuilt, 2024 International Codes). See the required-documents checklist on this page for details on each.

Ault requires 2 inspection(s) for a commercial tenant finish / remodel permit, in order: Rough Electrical / Plumbing / Mechanical, Final Inspection. Schedule each through Town of Ault (building official, plan review, and inspection services contracted to SAFEbuilt Colorado) (970-834-2844).

Apply through Town of Ault (building official, plan review, and inspection services contracted to SAFEbuilt Colorado) at 201 1st Street, PO Box 1098, Ault, CO 80610. Phone: 970-834-2844, email: info@aultcolorado.gov. Office hours: Town Hall does not publish specific daily office hours on its Contact Us or Building Permits pages as of this review; the Town's public-works page separately states Public Works operates 7:00 a.m.-4:00 p.m. Monday-Friday (except holidays), and the site-wide holiday-closure banner implies a standard 9:00 a.m. reopening time, but neither is confirmed as the Building Department's specific window. Call 970-834-2844 to confirm hours before visiting in person.. Official information: https://www.aultcolorado.gov/buildingpermits.

Ault, Colorado has adopted: 2024 International Residential Code (IRC) — per the '2026 SAFEbuilt Residential Application Check List' (Town of Ault Building Permits page, Helpful/Residential resource): 'All submittal information must comply with the 2024 I-codes and the 2023 NEC.'; 2024 International Building Code (IBC) — per the SAFEbuilt 'New Commercial Plan Submittal Procedure' and 'Commercial Tenant Finish/Remodel Plan Submittal Procedure' documents on the Town of Ault Building Permits page, both headed '2024 INTERNATIONAL CODES.'; 2024 International Energy Conservation Code (IECC) — required compliance documentation (ResCheck or energy rating report) explicitly named in the SAFEbuilt Residential Application Check List; commercial submittal procedures likewise require 'Documentation showing compliance with the 2024 IECC.'; 2023 National Electrical Code (NEC) — explicitly named in the SAFEbuilt Residential Application Check List ('...and the 2023 NEC').; 2024 International Mechanical Code (IMC) / International Plumbing Code (IPC) — inferred from the SAFEbuilt submittal procedures' consistent requirement of 'Mechanical/Plumbing Plans' stamped by a Colorado-licensed engineer, cross-referenced against the same '2024 INTERNATIONAL CODES' heading used for the IBC/IECC citation on the same documents; not independently named by edition number in the source text, so carried at 'partial' confidence for the specific IMC/IPC edition number. 2026-07-23 re-chase: the Town's own codified Municipal Code (Title 15 Ch.04, Sections 030/060), recovered via Wayback Machine archive of the now-defunct myaultgov.org portal (Sec. 030 Mechanical captured 2022-12-05: 'International Mechanical Code, 2018 Edition'; Sec. 060 Plumbing captured 2022-12-05: 'International Plumbing Code, 2012 Edition'), shows both trade codes were LAST codified at pre-2024 editions — older than, and in unresolved tension with, SAFEbuilt's current 2024-I-code submittal language; no live, currently-hosted Municipal Code exists to confirm whether these sections have since been amended to 2024 editions, so the specific currently-governing IMC/IPC edition numbers remain genuinely unconfirmed and are NOT asserted as '2024' anywhere in this file.; 1997 Uniform Building Code (UBC), Table 1-A — still the operative VALUATION-BASED FEE TABLE per the Town's 'Building Permit Fee Schedule' (Exhibit B — Fee Schedule for Services, a SAFEbuilt consultant-services fee exhibit posted on the Town's Building Permits resource list, last modified 5/19/24). This is a fee-calculation table, not a life-safety code edition, and is retained purely because it is the Town's actual current, published fee mechanism — it does not indicate the Town is still enforcing 1997 UBC life-safety provisions, which are superseded by the 2024 I-codes cited above.; No separate Ault-specific building-code-adoption ordinance was found published online: the Town of Ault Municipal Code page (aultcolorado.gov/MuniCode) states 'A Copy of the Ault Municipal Code is Available Upon Request' and is not hosted on Municode/eCode360 or any other public code-hosting platform; the Town's online Document Archive 'Ordinances' folder contains only a 'Non-Certified Copy of 2024 Model Traffic Code' (unrelated to building codes). The SAFEbuilt submittal-requirement documents (which explicitly compel 2024 I-code / 2023 NEC compliance and are hosted directly on the Town's own Building Permits page) are therefore treated as the governing, currently-operative code-adoption source for this file, consistent with SAFEbuilt Colorado being Ault's contracted building official/plan-review/inspection provider (per Exhibit B of the Town-SAFEbuilt consultant services agreement).. Local amendments apply — see the Ault overview page for the full list.

Yes. Restaurants and commercial kitchens require grease interceptor sizing, may require a fire sprinkler system if serving liquor over 5,000 sq ft, must meet Type I/II hood requirements, need two exits for occupant loads of 50 or more, and require Health Department (Weld or Larimer County) approval before the Certificate of Occupancy is issued.